Trim the pipe with a single Miter cut.

Click a button when you need to make a single straight or miter endcut on the pipe.

Beam Divergence defined and how to set

What beam divergence is and how to set it when tuning a machine

Prevent gouging at the end of cuts

How to get the torch to turn off at the right time to prevent gouging at the end of cuts.

Setting Root Weld Gaps for cuts

Explains Root Weld Gap and how to set it for various cuts

How to make the machine pause before a cut so you can jog in an offest.

Typically used for correcting variances caused by out of round or otherwise deformed pipe. Used when cutting Design Parts or Nestings. Also covered--how to skip cuts.

Describes how to load a pipe and use the chuck-end as a cut.

Eliminates the dead-zone loss. This can be used for parts and nestings where the pipe is pre-cut on the chuck end. Also covered: Reversing a nesting, and nesting longest parts at the chuck end.

Skip pre-cut endcuts, and align torch on partially cut pipe

Shows how to align the torch to skip a pre-cut endcut, and how to align the torch on partially cut pipe (with parts already cut from it).

Setting the pivot height for a manually rotated torch

How PypeServer manages NC files and the status of PypeServer Parts

Information specific to using PypeServer with HGG machines.

Setting up and using the Lincoln FineLine torch in PypeServer.

Getting started with PypeServer for your Lone Star Revolver

Set pivot height correctly for your Vernon machine

What is pivot height and how to set it.

Information and configuration specific for the Vernon Mini

Using Pypeserver with EdgeConnect Machines

Steps to setting up the torch for beveling

Document that works with the Vernon Machine Calibration Tool

Checking the pivot height on your torch

Use a laser in a fixture to check that the torch pivot height is correct on your machine.

How to troubleshoot and tune the machine when parts are not cutting to the dimensions in PypeServer

Getting started with using NC code on your Vernon machine

Testing the serial communications on machines with serial communications

Document explaining how to check software systems and test the serial hardware communications between PypeServer and your machine.